Авторы:
Издательство:
Дата издания
21.01.2026На каком языке издана
ISSN
2673-7094.Область исследования
Тип исследования
Аннотация (краткое описание)
Seasonal groundwater rise of 2.5–3.0 m leads to full saturation of the lakeside slope of the railway embankment, significantly reducing the strength of clayey–sandy loam layers. Laboratory shear tests showed that saturation decreases the internal friction angle from 24–26° to 16–19°, while effective cohesion drops from 12–18 kPa to 0–3 kPa, identifying the 3–6 m depth interval as the critical weak zone. These parameters were incorporated into PLAXIS 2D/3D hydro-mechanical models to assess the embankment behaviour under three scenarios: natural conditions, high water level, and reinforced configuration. Under elevated water levels, lateral displacement toward the lakeside increased to 0.16–0.21 m, and the plastic strain zone expanded by a factor of 2.4, reducing the safety factor from FS ≈ 1.32 to below 1.10. The proposed stabilization system—replacement of a 1.5 m weak layer, installation of geotextile reinforcement, and application of a bituminous waterproofing layer—substantially improved stability, reducing maximum lateral displacement to 0.12 m (≈43% reduction) and restoring the safety factor to FS = 1.25–1.40. The results demonstrate that low-cost geosynthetic barriers provide an effective and practical engineering solution for maintaining the long-term stability of railway embankments exposed to seasonal inundation.DOI
https://doi.org/10.3390/geotechnics6010010Тип публикаций
Практическое значение
In this study, the stability of a railway embankment located in the coastal zone of Lake Balkhash under water-induced softening was comprehensively assessed using laboratory direct shear tests and PLAXIS 2D/3D numerical modelling. The combined results provide a scientifically grounded basis for selecting effective engineering measures to protect track infrastructure in shoreline environments. The main conclusions are as follows: (1) The sandy loam–clayey soil complex typical of the Balkhash region exhibits a pronounced loss of structural integrity under wetting and full saturation. Within the 3–6 m depth interval, the high-plasticity layers reach liquidity index values of IL = 0.75–1.00, accompanied by a significant reduction in shear strength (φ = 16–19°, c ≈ 0). These conditions form the primary geotechnical prerequisites for lakeside-directed slip mechanisms. (2) Phase 2 of the PLAXIS 2D simulations revealed that seasonal lake-level rise increases hydrostatic loading on the embankment and leads to complete saturation of the underlying clayey layers. This process decreases the effective stress (σ′), expands the plastic deformation zone, and increases the maximum lakeside displacement to approximately 0.5357 m. Furthermore, the lateral displacement rate reached vx = 12–18 mm/day, while the safety factor decreased to FS < 1.1, indicating an unstable condition requiring a reduction in train operating speed to ≈20 km/h. (3) The proposed reinforcement system—replacement of the weak 1.5 m soil layer with a compacted gravel–sand mixture, installation of a 300 g/m2 geotextile, and application of a bituminous waterproofing membrane (Ruberoid) on the lakeside slope—significantly improved the hydraulic and stress–strain response of the embankment. The saturation zone narrowed, the plastic zone was reduced by 40–60%, lateral movement towards the lake decreased to 0.3–0.5 mm/day, and the maximum displacement was reduced to ≈0.18–0.19 m. As a result, the global stability improved to FS = 1.30–1.45, fully satisfying normative design requirements. (4) Numerical cyclic loading analyses demonstrated high long-term fatigue resistance of the reinforced structure. Accumulated residual deformation did not exceed ≈6%, the deformation field remained symmetrical, and no new indicators of lakeside slip were observed. This confirms that the proposed engineering solution is effective under realistic train loading conditions. (5) Overall, the findings indicate that the instability of railway embankments in the Balkhash region is primarily governed by saturation-prone sandy loam–clayey layers, and that seasonal lake-level rise activates the weakest parts of the structure. The proposed cost-effective and widely applicable engineering measures (geotextile + bituminous waterproofing + granular replacement layer) allow for the restoration of slope stability without the need for expensive geomaterials, ensuring the safe resumption of normal railway operations (60–70 km/h). The proposed reinforcement system is practically applicable to railway embankments located near lakes or in flood-prone areas with similar soil and hydrological conditions. The use of commonly available geotextiles and bitumen-based waterproofing membranes makes the solution suitable for long railway corridors where cost efficiency is essential. From a long-term perspective, maintenance requirements are expected to be limited, as the waterproofing layer is protected by the revetment and operates under relatively stable stress conditions. Routine inspections during scheduled track maintenance are considered sufficient to ensure its continued performance. In addition, from a cost-containment and sustainability perspective, the use of selected recycled aggregates may represent a viable alternative for certain embankment layers, provided that their mechanical performance, durability, and compatibility with geosynthetic reinforcement systems are adequately verified. Future studies focusing on the comparative behaviour of natural and recycled materials under coupled hydraulic and traffic loading conditions could further enhance the economic efficiency of railway embankment stabilization strategies. Similar findings regarding the effectiveness of geotextile-based reinforcement combined with waste or recycled aggregates under railway loading conditions have been reported in recent numerical and experimental studies [44]. Recent full-scale experimental studies have demonstrated that recycled construction and demolition waste aggregates can exhibit pullout resistance and mechanical behaviour comparable to natural aggregates when combined with geogrid reinforcement, supporting their potential use in sustainable embankment applications [45].Квартиль
Источник квартиля
SCImago (Scopus)Impact Factor
63Количество цитирований
0Данный документ располагается в коллекциях
Международные публикации ученых SU
Scopus
Файлы документа
geotechnics-06-00010-v3.pdf