
Авторы:
Издательство:
Дата издания
19.08.2025На каком языке издана
ISSN
20763417Область исследования
Тип исследования
Аннотация (краткое описание)
This study proposes a novel computational method, employing the integral dynamics of multibody systems to simulate the transverse vibrations of the rotor in a cantilever-type centrifugal pump. This method was applied to the kinematic assembly of the rotor and its supports, with the latter modeled as springs possessing stiffness and damping properties equivalent to those of real bearings supporting the shaft in an actual design. To investigate transverse vibrations within the system, three key observation points were defined—at the locations of the left and right bearings, as well as at the rotor’s center of mass—to allow for a thorough dynamic analysis. Additionally, the influence of motor rotational speed and the impeller’s eccentricity on the transverse vibrations of the supports and the shaft was examined. The results have revealed that transverse vibrations significantly affect the system’s dynamics at lower rotational speeds, leading to the classification of the shaft as flexible. As the rotational speed increases, the system exhibits enhanced dynamic stability. Furthermore, it was found that for impellers with a diameter less than 300 mm, the unbalanced forces are negligible and can be disregarded in pump design. To reduce vibration levels, an elastic damping ring was selected and incorporated into the system. This novel method provides an effective tool for analyzing the transverse vibrations of centrifugal pump rotors and for optimizing vibration mitigation strategies.DOI
10.3390/app15169132Тип публикаций
Практическое значение
In the present study, an integrated MBD and FEA approach was proposed to inves tigate the vibration behavior of a centrifugal rotor shaft. A rotor system, supported by a single-row radial ball bearing and driven by a DC motor, was modeled using ADAMS software. This study was conducted across various ranges of motor rotational speeds and disk eccentricities. The key findings of the current research are as follows: 1. The classical Jeffcott model was used as the basis of the analysis. Initial calculations revealed a discrepancy of 32–38% between the peak values of the computational and experimental models, indicating the need for further refinement. Future work should expand the model by incorporating the elastic properties of the coupling and electric motor to improve the accuracy of calculations and reduce deviations. 2. Animportant outcome of this study is that, for impeller diameters less than 300 mm, eccentricity has an insignificant impact on rotor vibration. 3. At a lowoperating speed (600 rpm), transverse vibration at three observation points has a significant effect on shaft motion. As the speed increases to the nominal rotational speed of the motor, the motion becomes more stable and the displacement response more consistent. 4. The vibration amplitude near the bearing is lower than at the shaft’s center of mass due to the higher stiffness of the bearings. It can therefore be observed that transverse vibration on the flexible shaft is greater than the vibration at both the left and right bearing positions. 5. The proposed model enables the selection of dynamic characteristics of integrated elastic elements and facilitates prediction of the damping effect on rotor vibrations through their application.Квартиль
Источник квартиля
SCImago (Scopus)Impact Factor
6Количество цитирований
0Данный документ располагается в коллекциях
Международные публикации ученых SU
Scopus
Файлы документа
статья МДРА 2025.pdf