
Авторы:
Издательство:
Дата издания
19.08.2025На каком языке издана
ISSN
20763417Область исследования
Тип исследования
Аннотация (краткое описание)
This study proposes a novel computational method, employing the integral dynamics of multibody systems to simulate the transverse vibrations of the rotor in a cantilever-type centrifugal pump. This method was applied to the kinematic assembly of the rotor and its supports, with the latter modeled as springs possessing stiffness and damping properties equivalent to those of real bearings supporting the shaft in an actual design. To investigate transverse vibrations within the system, three key observation points were defined—at the locations of the left and right bearings, as well as at the rotor’s center of mass—to allow for a thorough dynamic analysis. Additionally, the influence of motor rotational speed and the impeller’s eccentricity on the transverse vibrations of the supports and the shaft was examined. The results have revealed that transverse vibrations significantly affect the system’s dynamics at lower rotational speeds, leading to the classification of the shaft as flexible. As the rotational speed increases, the system exhibits enhanced dynamic stability. Furthermore, it was found that for impellers with a diameter less than 300 mm, the unbalanced forces are negligible and can be disregarded in pump design. To reduce vibration levels, an elastic damping ring was selected and incorporated into the system. This novel method provides an effective tool for analyzing the transverse vibrations of centrifugal pump rotors and for optimizing vibration mitigation strategies. © 2025 by the authors.DOI
10.3390/app15169132Тип публикаций
Практическое значение
The practical significance of this study lies in the development of an efficient computational method for analyzing transverse vibrations of cantilever-type centrifugal pump rotors using the integral dynamics of multibody systems. The proposed approach enables a more accurate assessment of the dynamic behavior of the rotor and its supports under various operating conditions, thereby improving the reliability, stability, and service life of centrifugal pump systems. The obtained results can be applied in the design and optimization of centrifugal pumps for selecting appropriate shaft parameters, bearing characteristics, and vibration damping elements. The study demonstrated that transverse vibrations strongly influence system dynamics at low rotational speeds, which is important for the analysis and design of flexible shafts. At the same time, it was established that for impellers with diameters below 300 mm, unbalanced forces are insignificant and may be neglected, simplifying engineering calculations and reducing design costs. An important practical contribution is the implementation of an elastic damping ring to reduce vibration levels. This solution can decrease bearing wear, minimize mechanical failures, and enhance the operational stability of pumping equipment. The proposed method can also be integrated into computer-aided engineering and simulation systems for the development of advanced pump designs in energy, oil and gas, water supply, and other industrial applications where centrifugal pumps are widely used.Квартиль
Источник квартиля
SCImago (Scopus)Impact Factor
5.5Данный документ располагается в коллекциях
Международные публикации ученых SU
Scopus