
Авторы:
Издательство:
Дата издания
19.07.2024На каком языке издана
ISSN
20734360Область исследования
Тип исследования
Аннотация (краткое описание)
This paper presents the results of an investigation of the possibility of the reliable determination of the residual stress–strain state in polymers and composites using a combination of bridge curvature, optical scanning, and finite element methods. A three-factor experiment was conducted to determine the strength of printed PLA plastic products. The effect of the residual stresses on the strength of the printed products was evaluated. By comparing the values of the same strength stresses, a relationship between the nature of the stresses and the strength of the samples was found. A tendency of the negative influence of tensile stresses and the opposite strengthening effect of compressive stresses was obvious, so at the same values of tensile strength, the value of residual stress of 42.9 MPa is lower than that of the fibre compression at the value of 88.9 MPa. The proposed new methods of the residual stress determination allow obtaining a complete picture of the stressed state of the material in the investigated areas of the products. This may be necessary in confirming the calculated models of the residual stress–strain state, clarifying the strength criteria and assessing the quality of the selected technological modes of manufacturing the products. © 2024 by the authors.DOI
10.3390/polym16142067Тип публикаций
Практическое значение
The practical significance of this study lies in improving the accuracy of determining residual stress–strain states in polymers and composite materials, particularly in additively manufactured (3D-printed) products. The proposed combined approach—using bridge curvature measurements, optical scanning, and finite element analysis—provides a more reliable and comprehensive assessment of internal stresses compared to conventional methods. The obtained results demonstrate the strong influence of residual stresses on the mechanical strength of printed PLA components. In particular, tensile residual stresses were found to reduce strength, while compressive stresses had a strengthening effect. This relationship is important for predicting the performance and durability of polymer-based parts. From a practical perspective, the developed methodology can be used to improve quality control in additive manufacturing processes by identifying unfavorable stress distributions and optimizing printing parameters. This allows manufacturers to reduce the risk of part failure, improve structural reliability, and enhance the overall mechanical performance of printed products.Квартиль
Источник квартиля
SCImago (Scopus)Impact Factor
9.7Количество цитирований
12Данный документ располагается в коллекциях
Международные публикации ученых SU
Scopus