
People who have visited the surface of Mars for the first time cannot survive in conditions of such dangers as ra-diation, micrometeorites and dust storms. But we offer the caves found on this Mars as a way to use them as a natural refuge from these environmental hazards. The gravitational field on the surface of Mars is about three times weaker than on Earth, and the magnetic field is too weak. Therefore, creatures that have left Earth, including humans, can live on the surface of Mars for only 30-40 seconds. Even the most powerful spacesuit can save a person's life for just a few hours. Martian caves weaken solar radiation almost three times and do not let it inside. Therefore, the study of Martian caves, conducting scientificallybased research to makethem the first habitat, is an urgent problem today. Therefore, it is advantageous to use the mountain caves of Mars as an underground habitat. Since atmospheric protection is minimal at high altitudes, scientific studies of the strengthand stability of the inner edges to Martian gravity are carried out to turn these caves into living quarters, such as mines, tunnels. Under the influence of various forces (gravitational, temperature, low-current, tectonic, etc.) of such structures on Mars, a mechanical andmathematical model is being developed to study the strength of cave dwellings, habitats.

This article provides information on the stability of the natural dam of Lake Kaiyndy in the study area. Lake Kaiyndy is located in the middle part of the basin and is fed by melted snow and rainwater. The flow of water from the lake is carried out by the surface. The lake belongs to the high category of mudflow hazard. During the technogenic development of this territory, one should considerthe negative impact of the additional load on the stability of the sides of the canyon and not expand the development of the territory towards the river. In the event of a lake outburst, the road bridge of the village ofZhalanash -the village of Saty, residential buildings and farmland of the village of Algabas and Zhanatalap of the Kegen dis-trict, the village of Shelek, the village of Masak, the village of Baiseit, the village of Malybay, with. Zhanasharua of the Enbekshikazakh district and the Bartogay reservoir of the Almaty region, road bridges, power lines. The total number of peo-ple in the risk zone is more than 2-3 thousand people. Also, the Kuldzhinsky Trakt highways, the Western China-Western Europe auto-ban, irrigation systems, the waterworks of the Kunaev BAC and other linear communications fall into the zone of influence. Lake Kaiyndy is a place of mass visits by tourists and vacationers. In summer, the number of people at risk can reach several hundred.

The article presents the results of a study of the thermodynamic-diagram analysis of the Fe-Si-Al-Ba multicomponent system, where, on the basis of thermodynamic data, the boundary ternary systems of the basic four-component Fe-Si-Al-Ba system are constructed. As a result, it was determined that the system consists of 12 elementary tetrahedra. For each of the tetrahedra, analytical equations are determined, with the help of which it is possible to establish the location in the factor space of the general system of the compositions of various metal melts with the calculation of their normative phase compositions. The correctness of the breakdown into elementary tetrahedra can be seen due to the volumes of the same tetrahedra, where the sum of these volumes is equal to one (1.00000). The quasi-volumes in the system Fe-Si-Al-Ba, simulating the compositions of the resulting metal products during the smelting of an alloy of ferrosilicoaluminum with barium in the process of reduction, have been established. As a result, it turned out that the Fe-Si-Al-Ba system does not include ternary and quaternary compounds, with the exception of interstitial solid solutions containing Fe-Si and Fe-Al phases doped with barium, as well as silicon-barium-aluminum containing eutectic. In this case, the region of the composition of the alloy with a barium content of 8-10% will be the most optimal. Further, with an increase in the concentration of barium in the alloy above 10%, it leads to the loss of barium with atmospheric oxygen, and also leads to a violation of the melting process.

Large amounts of waste from the enrichment of manganese ores, dispersed iron-and carbon-containing slurries accumulate at large processing plants, metallurgical plants, plants. Millions of tons of manganese waste have been accumulated at the Dzhezdinsky GOK. Processing of small and dispersed metal-containing industrial waste cannot be carried out by tradi-tional technology. The development and implementation of a new technology for processing these wastes into valuable metal alloys is a very urgent problem.In this paper, based on a comparative analysis of the theoretical approaches to the production of steel and ferroalloys of tra-ditional technology and newideas, the selection and justification of the preparation of the charge is carried out. It is shown that the theoretical foundations of the adsorption-autocatalytic mechanism can be revised from the point of view of the organization of metal production from the point of view of solid-phase reactions.The theoretical foundations of the «Dissociation-adsorption mechanism»are given, where the phenomenological phenome-non is focused on the fact that the dissociation of chemical compounds, including metal oxides, is inherent in them as well as their formation from individual elements regardless of external conditions. The influence of external factors, for example, energy (temperature rise), causes thermal dissociation, which does not so much prove whether dissociation exists or not at all, as it shows a specific degree of dissociation of the compound for the purposeful restoration of the element or the formation of a new compound.It is shown that the dissociation of metal oxides intensifies proportionally to a decrease in particle size and an increase in temperature. It is established that dispersed oxide materials can be metallized with solid carbon due to the reduction of iron within the temperature range of 950-1100°C.

During the processing of chromium ores, chromite concentrate is obtained for the production of ferrochrome, and waste is also collected -tailings beneficiation. Fragment and sludge tailings depending on the beneficiation technology.Finely dispersed sludge tailings of the Donskoy MPP of Kazchrome JSC are stored at the Dubersay and Akzhar tailings, which are man-made deposits (MMD) or man-made mineral formations (MMF). To develop a technology for processing sludge tailings, which contain up to 30% chromium oxide, their physical and chemical studies were carried out. According to the chemical analysis of sludge tailings, it follows that research should be directed to the removal of magnesium and siliconoxides, thereby increasing the content of chromium oxide to a standard chromium concentrate. A very thin dissemination of chromite with minerals of host rocks necessitates additional grinding of intermediate products, which are intergrowths of chromite with waste rock. Accordingto the results of fractional analysis and IR spectroscopy, the content of a large numberof flocculants in the studied sludge tailings and a large number of particles with a particle size of less than 20μm, which, in heavy liquid solutions, due to its small size, is in suspension and does not stratify, was revealed. According to the granulometric composition, it was determined that the sludge minus 0.071mm must also be classified into 0.04 and 0.02mm and enriched each class separately. It has been established that in order to obtain high technological performance, the traditional gravitational beneficiation scheme used at the DMPP is technologically cumbersome, because includes operations of flocculant disintegration, classifica-tion, grinding, beneficiation on concentration tables of each size class, regrinding of intermediate products. The results of the physicochemical study of chromium sludge tailings showed the need for a combined beneficiation scheme, including chemical enrichment with finishing of chromium concentrate by gravity beneficiation.

Forest fires greatly affect forest ecosystems, causing the loss of their biodiversity and their resilience. In addi-tion, they have a strong impact on the global carbon balance and, ultimately, climate change. This article analyzes studies ofremote sensing techniques and data used to estimate the area of forest burnt, fire severity, fire impacts, and patterns of refor-estation at the global level. The study discusses the results of an analysis based on 329 selected articles on major aspects ofthe field of study published in 48 journals over the past two decades (2000-2020). Article characteristics were analyzed, including journals, spatial extent, geographic distribution, types of remote sensing sensors, ecological zoning, tree species, spectralindi-ces, and accuracy measures used in the studies. The paper also discusses the main trends, problems and the increasing value of various remote sensing methods in assessing the area of forest fires, the severity of fires and post-fire recovery. Finally, it iden-tifies potential opportunities for future research using next-generation remote sensing systems, classification methods and cloud computing, as well as new process platforms for regional and large-scale research applications.

This article analyzes the change in the flow of the rivers of the Shu-Talas water management basin, consideringclimate change. During the study, linear trends in river flow were compiled, as well as meteorological parameters such as annual precipitation and average temperature in the basin region. The data were obtained from the annual collections of RSE «Kazhydromet»with further statistical processing. Data from 9 gauging stations of the considered basin and 9 meteorological stations closest to the basin were subjected to analysis. The materials obtained can be practically significant for long-term planning and development of large-scale measures for the integrated use, protection of water resources and solving complex problems of water supply inthe Republic of Kazakhstan.

In the article, the continuous growth in the development of the gold mining industry in our country, the growth in the consumption of metals and other minerals justify the search for and development of new minerals, the development of new efficient technological schemes for mining. processing of minerals, development of new types of raw materials from difficult-to-enrich ores. Research is aimed not only at the preparation and development of new deposits, the determination of the en-richment of gold-bearing ores, but also at the theoretical development of methods for separating the components of mineral raw materials.There are more than 2.000 gold deposits inthe Republic of Kazakhstan. Over the past two decades, studies of the structure of gold-bearing raw materials show an increasing trend in the extraction of ores.The continuous growth in the rate of development of the gold mining industry, the increase inthe consumption of metals and other minerals justify the search for and development of new minerals, the development of new efficient technological schemes for the processing of minerals, the development of new types of raw materials from hard-to-enrich ores. Research is aimed not only at the preparation and development of new deposits, the determination of the enrichment of gold-bearing ores, but also at the theoretical development of methods for separating the components of mineral raw materials. In the last two or three decades, the proportion of gold obtained from technologically simple gold ores has been steadily declining. In nature, gold occurs mainly in the form of a native metal, intermetallic compounds and minerals containing gold, silver, copper,iron, mercury, bismuth, platinum, palladium, iridium, rhodium and gold gelluride minerals. In addition, gold occurs in the form of compounds with organic acids.